HiFimeDIY USB Isolator

HiFimeDIY USB Isolator
Views: 214095 Brand: HiFimeDIY
Product Code: 10000071
Availability: In Stock
Qty: Add to Cart
The Hifimediy USB isolator is used to prevent ground loop noises and increase sound quality. It works by creating a new ground for the USB device so that it doesn't have to share ground with your computer and other devices that you might have connected in your house. This will prevent ground loops (but not all noises you might experience as not all noises are caused by ground loops). It will also protect the USB device and host from electrical shocks or static electricity shocks. It can improve the quality of the DC voltage that powers the USB device. This can improve performance of sensitive equipment like audio converters. ​
This Isolator doesn't require an external power supply. It features an isolated, regulated DC-DC module which is powered from the USB host (computer) and can give out 200mA, sufficient for commonly used USB equipment (but not all - check your device's power requirement!). Power is filtered with a LC filter featuring quality Sanyo OSCON caps.
It features a professional grade isolation chip, ADUM4160 and with an optimal layout it features signal isolation capability of 5000V and voltage isolation of 1000V.
A low noise regulator is used to power ADUM4160 and low noise DC-DC converter gives a clean 5VDC power to the connected USB device.
USB Full Speed 12Mbps is sufficient for samples rates up to 96kHz/24bit. It will not work with DACs supporting 192kHz/24bit samples rates as this requires USB "High Speed" 480Mbps. High-Speed isolator available here: Hifime High-Speed USB Isolator.
  • Signal Isolation 5kV
  • Voltage Isolation 1kV
  • Built in 200mA power supply from USB bus (no external power supply required)
  • Power supply LC filter
  • Copper ground
  • ADUM4160 Support USB "full speed" 12Mbit/s, but not "high speed" 480 Mbit/s. Support USB "Low speed" 1.5Mbit/s (internal switch needs to be set to L). See here for a hi-speed version
  • Size: 55x35mm + cable 10cm



  • Works with stereo DACs that supports sample rates up to 96kHz/24bit and that doesn't require too much power.
  • Suports other USB devices that runs on USB Low or Full speed modes. High Speed mode 480Mbit/s is not supported! 
  • DOES NOT WORK WITH high resolution 384kHz or 192kHz DACs (they requires USB High speed mode) - even when you play only 44.1kHz files. New High-Speed isolator here: Hifime High-Speed USB Isolator
  • DOES NOT WORK WITH multi channel DACs/soundcards. They will also require High speed mode.
  • Supports Low speed devices (mouse, keyboards, some midi converter) through internal switch. You need to open the box and move both switches to the L position.
  • Some computers will not wake up the isolator after sleep/standby, requires to disconnect and reconnect the isolator.
  • Works with M-Audio MKII card, and most USB mics. Confirmed working with Prophet 12 synthesizer and other synthesizers (for MIDI).
  • Does not work with Focusrite sound cards!


Will the USB Isolator get rid of my buzz noise?
Buzz noises are often ground loop problems, and this is exactly what the USB isolator will remove. However the noise you're experiencing might be caused in another way and might not be removed by the isolator. We do accept returns when it doesn't work or remove the noise from your device.

Will it work with my DAC?
It works with dac's that support up to 96kHz/24bit, it does not work with 192/24 sample rates. 
Also, some dac's requires more than 200mA power. This might be if they have a headphone amplifier, or a MCU that draws more power.
New High-Speed isolator available here: Hifime High-Speed USB Isolator  (supports samples rates above 96/24)

Do you offer warranty ?
Yes, we offer a 1 year warranty on all our products. We will ask you to pay shipping cost for sending the item back. We have return addreses in China, USA, UK and Germany.


It doesn't work, do I need to install a driver?
The USB isolator is "transparent" for the computer, so there are no drivers to install. However, it doesn't work with all USB devices. Your device does probably either require too much power, or needs USB High speed mode (480Mbps).
Some further explanation:

  • USB ports can supply up to 500mA of power, while the USB isolator will output max 200mA. Some devices will require more than 200mA and will not work with the USB isolator. If your sound card has mic preamps or other features that draws a lot of power, then it probably will not work if it gets all it's power from USB. 
  • If your DAC supports sample rates above 96kHz/24bit, then it will require USB High Speed (USB Audio class 2) and will not work with the isolator. Also, if you have a 96/24 sound card with 4, 8 or more channels, it will also require USB High speed mode. 
Model: ISO-2
1 ( 1 / 5 )
Doesn't work properly with Steinberg UR242. Drops connection out of the blue at random intervals. HIFIME REPLY: UR242 is a 192kHz sound card and requires high-speed mode. You can return it for a refund.
5 ( 5 / 5 )
Works as promised. Connected to an USB hub which sends MIDI to hardware synths. Zero problems.
5 ( 5 / 5 )
Today i received my isolator and OMG this improved my sound so much it's beyond my expectations. For this price this little box of magic is worth it double. I'm using this product in combination with my Audioengine D1 DAC that i have hooked up to my LSR305's. No more PC noises no more ground loop buzzing. I can finally put my speakers volume up to 10 without hearing all of the annoying sounds i mentioned. I'm definitely picking up the high speed version when i'm upgrading my DAC in the future.
5 ( 5 / 5 )
Works great! I had serious issues with GPU coil whine being transmitted through the USB DAC, it's all gone now.
5 ( 5 / 5 )
Very good product, solved problems with high pitched noise (ground loops..) on my Presonus USB interface. God service, fast delivery. Thank you

Write a review

Your Name:

We do not moderate any reviews except those postings that are clearly not reviews. Questions or comments that are not reviews might be deleted. If you have a question, please contact us. Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

The Hifimediy USB isolator is used to prevent ground loop noises and increase sound quality. It work..
25 reviews

This model is discountinued. Look at the 9018 model instead:
43 reviews

This digital to analog converter is even smaller than our original Sabre DAC and offers most of the ..
12 reviews

Our original and bestselling USB DAC with Sabre ES9023 DAC chip, Savitech SA9023 USB receiver. ..
43 reviews

Best portable DAC in Norwegian newspaper VG! 6 stars and best portable DAC of the Year in Lyd og Bil..
39 reviews

US :